Dynon ILS pointing backwards

Dave Anderson

Dave Anderson

Line Up and Wait
Joined
Aug 31, 2021
Messages
504
Location
Twice a month beside Biden's WH retreat.
Display Name
Display name:
SkyDreams
Anyone know what would cause this.

shooting practice approaches and ILS tuned on GTN and the Dynon needle is showing away from the ILS

Since the needle was to the left, we had to correct to the right. Glad these were practice approaches. Is this a setting issue or an internal issue
 
What was your course set to? If it was accidentally set to somewhere close to the reciprocal of the inbound course a lot of units will automatically treat it as a back course and reverse the indications.
 
Dave Anderson said:
We were using autopilot so I’m assuming course was correct but could be wrong
Click to expand...
Pilot error. Namely, the bolded part.

other than that, since a Localizer only has one "course" it's hard to tell what is going on. Has it happened before? Were you on "green needles" at that point or still following GPS? Was there a course reversal that wasn't cleared? Was a BC of REV button pressed?

If you "set it and forget it" and just "assume" It's right, it's hard to know. But remember the system only does what you tell it to.
 
Yep, the two issues:
1. An HSI will "reverse sense" if you have the course arrow pointed backward.
2. ILS transmitters to opposite ends of the same runway usually use the same frequency (but the ID changes).
 
Dave Anderson said:
Thanks for the replies Backcourse sounds likely the culprit. I'll confirm ILS too.
Click to expand...
Your auto pilot was likely slaved to your heading bug and corse is set to a different bug so be sure you have both set up to a separate knob control so you remember to set them both separately. They both will display below the HSI one on the left the other on the right side
 
You must log in or register to reply here.
Back
Top