Anybody have a 3D printer? I need a knob.

J

JOhnH

Touchdown! Greaser!
Joined
May 20, 2009
Messages
15,163
Location
Florida
Display Name
Right Seater
Home Airfield
KOMN
The knob on the Garmin 696 is split and they don't appear to be available. I found the knob on Thingiverse. As far as I can tell, it has the directions to print the knob, but I don't have a 3d printer. Anyone care to give this a shot for a reasonable fee?

https://www.thingiverse.com/thing:3873863
 
Kind of a fugly knob, but I should be able to slip it under the radar and get a resin print today or tomorrow. Not sure what color it will be.
upload_2022-3-30_8-34-39.png
 
I've had one for 3 years now and never had the time to open it! Talk me into getting at it!
 
I have a printer, but not home until Sat. PM me if you still need it.

My printer is entry level, so not entirely smooth. I typically use a small amount of spray filler/primer on a part before painting it and it looks great.
 
Let'sgoflying! said:
I've had one for 3 years now and never had the time to open it! Talk me into getting at it!
Click to expand...
Next time I’m in Big Spring, where I was born, I’ll give you a ride in a V-tail Bonanza. (You aren’t a doctor, are you?)
 
You must log in or register to reply here.
Back
Top