My dog has an up coming procedure.
Due to his aggressive nature, my vet wants to give me the sedation and inject my dog at home before hand.
Is this really doable? My concerned is that I jabbed my dog’s behind incorrectly and end up killing him.
I live in Edwardsville Illinois; (East Saint Louis). I’m requesting a referral for a wood structures repair service for my home’s crawl space.
Thank you!
Fuel stain around this part of carb.
This is installed on my O320, recently overhauled carb with just 50 hours on it.
Any concerns I should be aware of?
I’m looking at buying a home from (unlisted) private sale.
Will the title company I’m using take care everything or do I need a real estate attorney to review closing documents?
My garage is not insulated.
If I use insulation board to box in my work area during Winter, would that help keep in the warmth? (I would also run a space heater though.)
Thoughts, ideas?
Thanks!
I'm looking at a used 2008 Ford Mustang GT with 122K+ miles and listed for $12K. It had five previous owners...
Like your opinion if this is a buy to stay away from, or ok to buy if I like to tinker and work on it?
Thanks!
Hello,
I’m looking to replace my carb heat control cable with a button on the knob to lock and a ‘cable end’ to secure it on the carb heat door’s lever.
Anyone know the part number or name so I can order it at one of the website stores?
Thanks!
I’ve had the same compass in my RV6 for close to twenty years now.
During the last couple flights I noticed it’s heading being off by 30 degrees from what my Dynon EFIS is showing.
Is it time to replace the magnetic compass?
How accurate are the little stick on ASA brand CO detectors?
I have a slight darkening around the edge of the detector circle and that's it.
I can't tell if that means there a leak into my cockpit.
Appreciate any good advice.
Thanks!
Do these seals look bad or can I continue to use them on my Lycoming.
The photos are of the # 4 cylinder seals. The overlap is right in the back outboard corner.
I've started my break in post major overhaul of my O320.
During the 2 hour flight at 75% recommended power, my #3 & 4 CHT were at 415 to 420. The CHT for #1 & 2 were in the 375 to 385 range.
Is that normal for the back two cylinders?
Hello!
Just received my overhauled oil cooler.
I will be reinstalling it back on my Lycoming O320.
I heard a few suggesting I flush it out with mineral spirit and or air?
Is that really necessary post overhaul?
Thanks.
I've been reading about how to hang a Lycoming 360 on an RV-8...
Its recommend that it be done with some assistance, not solo.
What's the risk? Is it really that hard to do it without some extra helping hand(s)?
Is there some special techniques to doing it by yourself?
What is the tribal...
I’m looking to buy steel angles in the St Louis MO area. If you know of one, please advise. The shipping cost for raw material was too much.
…trying to build my own metal brake. Thanks !