vontresc
En-Route
Well I must have accumulated some bad karma somewhere. While Attempting to change out the leaky main seal on my '82 R65 I managed to push the crank out of place. Well you may ask why this is so bad? There is a thrust washer on the inside of the case that falls off of its retaining pins if the crank moves backwards. Now I get to do a COMPLETE top and bottom end on the engine .
I figure it will be a nice educational experience, but I was hoping to be on the road a bit sooner.....
Oh Well At Least I will know that the engine will be up to spec after I am done with this ordeal.
Pete
P.S. I think I will try to document the teardown on the web
I figure it will be a nice educational experience, but I was hoping to be on the road a bit sooner.....
Oh Well At Least I will know that the engine will be up to spec after I am done with this ordeal.
Pete
P.S. I think I will try to document the teardown on the web