- Joined
- Jul 29, 2011
- Messages
- 1,466
- Display Name
- MountainDude
- Home Airfield
- KPDX
This is Insight G2. Has worked flawlessly for 5 years.
During the last annual, the only electrical work that was done was to replace the landing light bulbs.
After the annual, I noticed these white rectangles blocking the digits on the screen.
I sent the photo to Insight Avionics, and they said I would have to ship it to them for a re-calibration (whatever that means).
Even if they dont charge for the recalibration, I figure it will cost me several hundred $ to have it taken out, shipped both ways, and reinstalled.
Anyone have a better suggestion than to send it to them?
During the last annual, the only electrical work that was done was to replace the landing light bulbs.
After the annual, I noticed these white rectangles blocking the digits on the screen.
I sent the photo to Insight Avionics, and they said I would have to ship it to them for a re-calibration (whatever that means).
Even if they dont charge for the recalibration, I figure it will cost me several hundred $ to have it taken out, shipped both ways, and reinstalled.
Anyone have a better suggestion than to send it to them?
