Tom-D
Taxi to Parking
- Joined
- Feb 23, 2005
- Messages
- 34,740
- Display Name
Display name:
Tom-D
I am overhauling a 0-200 and the pictures below are of the starter that WAS installed.
Would you:
rebuild it?
Buy a new standard starter?
Buy a Skytech?
note the brushes are riveted on, and the armature brushes are hard wired to the field.
Armature is already been cut, and is now too small to cut again.
bearing are worn out.
The brushes can be replaced, ($8) as can the bearings ($.50)
the armature can be run as is by shining it up with 1500 grit paper.
Your the owner you tell me what you would do.
Would you:
rebuild it?
Buy a new standard starter?
Buy a Skytech?
note the brushes are riveted on, and the armature brushes are hard wired to the field.
Armature is already been cut, and is now too small to cut again.
bearing are worn out.
The brushes can be replaced, ($8) as can the bearings ($.50)
the armature can be run as is by shining it up with 1500 grit paper.
Your the owner you tell me what you would do.