Garmin 430 Help --- Taking TIS out of Standby Mode

[ruthsindelar]

Does anyone know how to take a Garmin430 Traffic (TIS) out of "Standby Mode"?

We recently had some avionics work done to our plane (installed a JPI 830 engine monitor...love it) and ever since then the TIS has been in Standby Mode. The JPI830 does talk to the GNS430 so I thought maybe a switch got mis-set. Avionics shop says that is not the cause.

Here is what I tried. I highlight Stanby on the TIS page by pressing the small right hand knob to get the cursur. I think select OPER and hit enter. That should work according to the manual but it doesn't. The unit stays in OPER mode for about 2-3 seconds and then reverts back to Standby.

Any thoughts or suggestions. I leave on a trip out west on Wednesday and I would love to have it working prior to then...

Thanks

 

[poadeleted20]

Ditto what I said to Greg about his similar sort of issue -- take it back to the shop and tell them to fix what they broke.

 

[John Collins]

Have your shop check the GTX330 to make sure that TIS is enabled in its configuration.

 

[wsuffa]

Have your shop check the GTX330 to make sure that TIS is enabled in its configuration.

And that the data communication protocols are correct.