EdFred
Taxi to Parking
I have no idea why I didn't notice this before, but my right seat in my 180 sits a bit further back then the left seat. So I crawled under the seats. Ok I crawled around to look under the seats. I don't think I could actually fit under them myself. And the seat rails have a hole pattern like:
O
O
O
O
O
O
.
.
O
.
.
The small green dots are where the rail stops are at on the left side and the orange dots are where the seat rail stops are on the right side. And yes there is a larger gap to the last set of holes. (seems to be about 3-4") I checked the cutouts which allow the seats to be removed, and they are in the same spots on each side, and if I remove that rail stop on the left side and use that last hole, it is a much more position for me at 6'-2". Why would the right seat be allowed to use that furthest rearward seat stop, and the left seat be forced to sit forward further ? Anything that would prevent my mechanic from tapping a hole in the left side rails in the same position as the right side rails?
O
O
O
O
O
O
.
.
O
.
.
The small green dots are where the rail stops are at on the left side and the orange dots are where the seat rail stops are on the right side. And yes there is a larger gap to the last set of holes. (seems to be about 3-4") I checked the cutouts which allow the seats to be removed, and they are in the same spots on each side, and if I remove that rail stop on the left side and use that last hole, it is a much more position for me at 6'-2". Why would the right seat be allowed to use that furthest rearward seat stop, and the left seat be forced to sit forward further ? Anything that would prevent my mechanic from tapping a hole in the left side rails in the same position as the right side rails?