GLMS_NC
Line Up and Wait
- Joined
- Apr 3, 2015
- Messages
- 727
- Display Name
- Rick
Recently completed panel upgrade and the old components are for sale.
All were working when removed (see note below*).
Buyer pays shipping. Paypal only.
Century Disconnect relay 1B759 - $20
Century Mode Programmer 1C771 - $OLD
Century Pitch Servo 1C882-1-806 - $25 (see note below*)
Century Roll Servo 1C927-806 - $75
Century Rudder Servo 1C465-676y - $75
Century Trim Servo 1C469-6-674 - $75
Century Yaw Damper Controller 1C763-2 - $50
Century Yaw Damper Computer 1C753-201 - $75
*About the pitch servo – I was having a pitch oscillating problem. I don’t know if the problem was wiring, the pitch servo, or the flight computer. I wasn’t going to spend loads of time and money tracing; I went ahead and upgraded the entire system. Roll, trim, yaw damper, and everything else was working fine when I pulled it out. AP was connected to a Garmin G500 via the Gad43.
All were working when removed (see note below*).
Buyer pays shipping. Paypal only.
Century Disconnect relay 1B759 - $20
Century Mode Programmer 1C771 - $OLD
Century Pitch Servo 1C882-1-806 - $25 (see note below*)
Century Roll Servo 1C927-806 - $75
Century Rudder Servo 1C465-676y - $75
Century Trim Servo 1C469-6-674 - $75
Century Yaw Damper Controller 1C763-2 - $50
Century Yaw Damper Computer 1C753-201 - $75
*About the pitch servo – I was having a pitch oscillating problem. I don’t know if the problem was wiring, the pitch servo, or the flight computer. I wasn’t going to spend loads of time and money tracing; I went ahead and upgraded the entire system. Roll, trim, yaw damper, and everything else was working fine when I pulled it out. AP was connected to a Garmin G500 via the Gad43.
Last edited: