Used very little. A few scuffs on the bottom. Bag can be taken apart to make the smaller models that Brightline advertises. 200 plus 25 to ship.
Sent from my iPhone using Tapatalk
Well we got it fixed. There is a clevis pin on the door tube assembly which is used to connect it to the door latch. That pin sheered off disconnecting the latch from the tube assembly. My mechanic and I got a new clevis pin and welded it in like the last then put everything back together. Works...
Took my 1980 Archer ii up tonight. When I got back to the fuel pumps I could not exit the aircraft. The door latch on the bottom seems to now be disconnected from anything inside the door. To make matters worse the baggage door was locked. I was so embarrassed as no one was there and I had to...
GX 60 GPS COMm annunciations panel 2 cards and a writer 1000.00
Kn 64 DME 800.00
Kma 20-150.00
4place Intercom 150.00
All were working when removed for upgrade last week. Shipping negotiable.
Sent from my iPhone using Tapatalk
Located in Memphis TN. I bought into a partnership about a year ago and we have headsets in the airplane. This was my passenger headset as I have a Bluetooth A20. Now that I fly an airplane with headsets in it I do not use the backup so I just want to unload it.
Sent from my iPhone using Tapatalk
Hey gang I have a Bose a20 ga plug non Bluetooth. New ear seals. To be honest they are in great shape and I can’t even find a scratch on them. Case included. 600 plus actual shipping cost.
Sent from my iPhone using Tapatalk
I'm not sure. In our case two of my partners work for cell phone companies. So they just put an old hot spot in the hanger with very limited data on it. It works great. No connecting or disconnecting for us.
Sent from my iPhone using Tapatalk
We use the WEMO switch for our pre heater as you described. The nice part about it is that we set a rule on it to turn off after four hours. That way if you lose connection or forget to turn it off and not fly it will shut off automatically.
I talked to uavionix a few wells ago and pre ordered the skybeacon. I talked with the rep and they said the archer would be included in the stc. Well after looking at the stc I do not see the PA 28-181 only the PA 28-180. Does this mean it will not be approved for the archer? Just curious of you...
Hey gang me again. Just wanted to run some stuff by y’all. I have a piper archer ii and I had noticed I was only making 2200 rpm static when going full power. Poh says that should be 2325. This is with a standard prop which I have. I’ve also noticed that the number 2 egt runs about 90-100 hotter...
I just changed a Curtis CCA 1550
7/16 is the nut size.
Torqued it with a wrench with a 7/16 crows foot at 90 degrees. Curtis called for 45 inch pounds.
Sent from my iPhone using Tapatalk