Tom-D
Taxi to Parking
- Joined
- Feb 23, 2005
- Messages
- 34,740
- Display Name
Display name:
Tom-D
The wire diagram says to place a 1500 ohm resistor between pin 7&8 if the audio panel is not used.
what does it do?
What will happen if you don't?
Today while I had the 170 out of the hangar I tried the radio, the intercom works on all stations, the radio will transmit but not receive.
Pin 7&8 are both audio pins.
7 = Aux audio in
8 = low level audio out.
what does it do?
What will happen if you don't?
Today while I had the 170 out of the hangar I tried the radio, the intercom works on all stations, the radio will transmit but not receive.
Pin 7&8 are both audio pins.
7 = Aux audio in
8 = low level audio out.