n12365
Pre-takeoff checklist
I recently had a local A&P install a JPI fuel transducer in my 172. Attached is the best picture I was able to take of the installation. Is it permissible to use a hose support clamp over the firesleeve that is over the AN816 fitting used to connect the fuel hose to the transducer?
The use of plastic tie wraps on the firesleeve and the routing of the transducer that puts it above the carburetor are also concerns, but the hose clamp location is what worries me the most.
Ryan
The use of plastic tie wraps on the firesleeve and the routing of the transducer that puts it above the carburetor are also concerns, but the hose clamp location is what worries me the most.
Ryan