Hey guys,
I appreciate all of the feedback. I went ahead and paid for a new prop.
I was contemplating getting a second decision, but I'd still have to pay for the "7 hours @ $150 an hour" that they had put into it already along with the shipping. However, if I purchased a new prop it would be...
Hey everyone,
Again, I appreciate your suggestions and well wishes.
I've succumbed to binge eating as a result of this. I'm on my third pack of M&Ms. Don't judge me :)
I genuinely don't think that American prop is lying about the prop being below minimums, but the bottom line/question: is it...
Hello everyone,
I hope you're all doing well!
I got some unfortunate news today and was hoping I could pick some of your brains regarding the issue.
I have a Cessna cutlass 172RG and the prop was spitting out some grease. I took it to our local mechanic shop here in Las Vegas as we don't have...
Hello everyone,
Does anyone happen to know why my throttle will progress inward on its own unless the friction lock is set abnormally tight?
I have to make the friction lock tight to the point where it takes some effort to slide the throttle in and out.
It’s a Cessna 172. I’ve flown several...
Hello everyone,
I just purchased the iPad 11" and haven't found any yoke mount cases online for it. Is anyone else using it?
I think it might be too bulky..
Any advise?
Thanks,
Nathan
Are you sure this is correct?
I don't think our tank is 12" deep.
Even a cantilevered wing like the 210 and cardinal are only about 10”. A strutted wing is not as thick so it should only be 8 inches or so.
Thank you!
Hello everyone!
Does anyone know whether or not I can use a 24v led post light to replace a faulty 28v post light? My system is 28v
24v post light:
https://www.aircraftspruce.com/catalog/elpages/panelpost13-15801.php?clickkey=241725
I’m flying a cutlass 172rg.
Thanks in advanced,
Nathan