Recent content by malichite

First start done! IA came down yesterday and inspected everything. Couple minor things to wrap up and we are ready to fly. Paperwork getting filled out now and hopefully we will be in the air by the end of the week.

Not sure on final weight yet. Doing W&B this week. Im hoping the 4+ish lbs we moved almost to the tail will help contract and weight of the prop.

I think it's the picture. It is tight, but I can get it in and out in a couple min.

CHTs and EGTs wired up on the left side, fuel flow, oil pressure wired up. Still need to secure the wiring on those. Also need to figure out routing for the upper plug wires still. 99% of the wiring now complete inside as well. The punch list is getting pretty short.

I've had smoke in the cockpit, a frozen elevator, zero oil pressure, parts fall off an airplane, miss rigged airplane. Not once have I got a call from the FAA, had to fill out excessive paperwork or anything. ATC is there to help, and have always been amazingly helpful...except for when I...

Another wiring shot

Thanks. I can't stand zip ties

Got the wiring complete on the right side of the engine. Also finished getting the last fuel lines made. Just need to get them bundled up. Also getting the last of the panel side wiring complete. Starting to smell like a first start soon.

The trick is to just land as slow as possible. :rolleyes:

All this time putting fish in tanks and ponds and being super careful about them adapting to the new water temp and stuff...Apparently I can just drop them in from a few hundred feet haha

It is a lot, but not that terrible. They send the harness all terminated at the instrument side and everything is labeled very well. I just made sure to group everything into bundles (Right side cht/egt, left side cht/egt, 3 pressure transducers...) and then ran them where they needed to be.

It’s excellent while acting as supervisor :D

No, none of it was, but we found a lot of scoring on one cylinder

CL? You mean the old civic hatch?

I think that mostly catches up where I am at now. I'm hoping to complete getting the wiring back up under the panel this week and try to get the panel firewall back closed up and complete for good. All that will be left then is firewall forward.