Recent content by LSK

That was all installed back in 1982 - I think it was top of the line back then perhaps

I have a KI209A to be installed - in the attached pics I think the easiest plan is to remove what is circled red and move down what is circled in green leaving room for the 175 and 209a at the top - thoughts?

We messed with it some more tonight - no luck - see what you can make of this - we removed the wires from the VR - attached bat and arm together and started the engine, yes with avionics off, then touched the field wire to ground - ran engine up slowly and around 1300 the voltmeter started up...

out of curiosity what labor hours were you being quoted for 175 install

Specifically the complaint is the generator is not charging the battery - Things we have done/checked: -Grounded field wire and ran engine up for a few seconds and used a voltmeter to determine generator is increasing output with engine rpm and it was - installed a new delco VR and flashed...

Both do - Im mot sure which indicators it has exactly - thinking about adding either a garmin 106 or ki209A

1965 cessna 172

Anyone have and willing to share a flow chart troubleshooting guide for the 1965 cessna 172 generator system in terms of what should and should not have continuity and acceptable resistance between various points - obviously we are having a issue with the generator and working with our A&P to...

Plane is an older 172 - currently has two kx155 nav/coms in it Wanting to get it set up to use for some ifr training, on a budget of course These are the two options we are considering and would like to hear some others thoughts on one versus the other - 1) Add a 430w, FS210, cdi, remove one...

Have you sold this yet or still have it for sale? Thanks

I saw a guy post on FB this morning with same issue - however, the guy on FB had taken a perfectly reliable carb engine and thrown money at it converting to fuel injection and an electronic ignition - I doubt his engine will ever be as reliable again as it originally was - in your case can you...

Anyone know if there is a torque spec for the screws on the Cessna fuel sending unit - If it matters the 1962-67 era standard tanks

I asked a similar question about a month ago without much feedback - anyone have any experience or opinions on these two brands in terms of build quality and cooling efficacy ? thanks in advance

Need a 7 row cooler - Niagara is on back order until ............... Aero Classic versus Air Flow X series Air Flow is about $100 more than the Aero Classics Any suggestions or recommendations from the crowd

What is the procedure to test a generator VR suing a multimeter? Problem is the gen light inside comes on dimly sometimes, and goes off and on when landing or hitting a bump in taxiway - All the wire terminals are tight at the connection - still need to spend some time to verify that the...