If Ducati made an airplane...

FastEddieB

Touchdown! Greaser!
Joined
Oct 14, 2013
Messages
11,403
Location
Lenoir City, TN/Mineral Bluff, GA
Display Name

Display name:
Fast Eddie B
...would you fly it?

My Sky Arrow has had recurring problems with charging over 10 years and about 470 hours. It was hard to tell whether it was due to bad/loose connections in the multi-pin connector feeding the Ducati regulator or actual problems with the regulator itself.

The plane would often go for years with no problem, but it reared its ugly head again a few weeks ago - I started the plane up and the GEN light stayed on solid. Suspecting the plug, I found this:

29952340433_ab67053f5a_z.jpg


Cleaning up the spades and applying some Stabilant-22 worked, but the other day I saw the GEN light flicker on base, which it never does normally.

I knew RV owners have had their issues with the Ducati regulator, often blamed on it not cooling properly in its original location on RV12's. Some relocated the regulator to a cooler location, and some had converted to a John Deere part to good effect.

In any case, I installed a John Deere ($23.10 from Amazon*) today with the help of a friend. Here it is in place:

32312686585_408b9bbcbd_z.jpg


Moving away from the multi-pin connector should make it easier to check connections - one theory on the Vans forum was that the multi-pin connection did not allow the terminals to seat fully, leading to overheating.

We held out breaths but on startup everything looked good - no GEN light and good voltage:

32312829845_0a86080509_z.jpg


Note: My plane's voltmeter has always read about 1 volt high (1), but I tend to trust the bus voltage shown on my Garmin (2).

The complete story here if you're interested: http://www.vansairforce.com/community/showthread.php?p=1141868

Of course, only an option if one is Experimental. Still, something to consider if you are and are having issues.

Now, we just have to source a "Power by John Deere" decal! In John Deere green, of course!


*Price now up to $24.20. I just ordered two more to carry along as spares.
https://www.amazon.com/gp/product/B00MWOQWP4/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
 
Have you poked around with a multimeter?

John deer does sound a lot more reliable than duke parts.
 
Well done! And to fund anything with the John Deere name for under a thousand dollars is almost unheard of.
 
The Ducatis commonly have actual regulator failure; many owners have gone to MOSFET units that are more efficient and generate less heat, and are considered to be more reliable. VR connector issues are pretty common on bikes, mainly due to heat. Relocating is the first step, and replacing any cheap connectors is smart, but requires some wiring savvy and good-quality tools.
 
Eddie that is one sweet looking panel. That thing must be fun to fly.
 
AFAIK Sky Arrow has a tip-up panel, which allows an easy access. On my Carlson one has to lay on his back and then slither under the panel around the control stick, taking care not to puncture the fuselage fabric.
 
Owning a Ducati is like having a gorgeous, neurotic Italian supermodel for a girlfriend that overspends her credit card. But you keep her 'cause she lets you ride her.
Ducati. Looks like a supermodel, pulls like Peterbuilt, goes like a batoutahell.
There is an Italian airplane, a SAIA Marchetti 260, that is pretty Italian cool. Big engine, aerobatic, fast.
 
AFAIK Sky Arrow has a tip-up panel, which allows an easy access.

Close, but not quite - at least on mine.

Basically two 10mm nuts under the panel, and after disconnecting all the wire bundles and cables, I can have it off and on the bench in under 10 minutes:

12663496433_31b09f84ca_z.jpg


23253925459_8b7fcd6c78_z.jpg


15364587215_3df5633ff2_z.jpg


I pull it as part of the annual to more easily access the rudder pedal hardware, and to just look around.
 
Close, but not quite - at least on mine.

Basically two 10mm nuts under the panel, and after disconnecting all the wire bundles and cables, I can have it off and on the bench in under 10 minutes:
...

I pull it as part of the annual to more easily access the rudder pedal hardware, and to just look around.

Now that is just cool.
 
How about a tiebreaker; put the VOM on it.

I think I have before, but will again. Probably get to the hangar tomorrow and will report back.

I think the Garmin is right, because even with the engine off and the master on the plane's voltmeter shows about a volt above the 12.7v or so you'd expect.
 
Owning a Ducati is like having a gorgeous, neurotic Italian supermodel for a girlfriend that overspends her credit card. But you keep her 'cause she lets you ride her.
Ducati. Looks like a supermodel, pulls like Peterbuilt, goes like a batoutahell.
There is an Italian airplane, a SAIA Marchetti 260, that is pretty Italian cool. Big engine, aerobatic, fast.

Another typically gorgeous bit of Italian aeronautics -the F.8L Falco. Looks fast standing still. All wood!

IMG_0195.JPG
 

Attachments

  • IMG_0195.JPG
    IMG_0195.JPG
    711.9 KB · Views: 5
If Ducati made an aircraft I envision looking like this ;
 

Attachments

  • image.jpeg
    image.jpeg
    89.9 KB · Views: 39
  • image.jpeg
    image.jpeg
    89.9 KB · Views: 34
Owning a Ducati is like having a gorgeous, neurotic Italian supermodel for a girlfriend that overspends her credit card. But you keep her 'cause she lets you ride her.

Yeah, but what a ride !
Pretty accurate description of Mrs. VanDelay BTW.
 
I had a 1992 (I think) 900SS:

32327126596_8fb73a0017.jpg


As an aside, I think this photo was taken with my second digital camera - a Sony Mavica that stored photos on floppy disks!
 
How about a tiebreaker; put the VOM on it.

Got to the hangar and made a short flight yesterday.

Voltage readings (engine off):

Battery (Aerovoltz lithium iron) with Master Off: 13.25v
Battery with Master On: 13.11v
Garmin: 12.7v
Panel 12v outlet: 12.97v
Panel voltmeter: about 13.8v (a little parallax error in photo below)

Engine off:

32252397142_b4d3a80e48_z.jpg



Went flying, and with just the strobes and landing light on, saw the voltage gradually go from about 13.7v to 14v where it seemed to level off:

32282261021_a231eb95c6_z.jpg


This is I think about .3v higher than the Ducati.

I was a little surprised at the high resting voltage - I'm used to seeing about 12.7v on most lead-acid batteries. But the Aerovoltz data sheet says that higher voltage is typical, and the 14v charging rate is in the acceptable range:

32252399662_462bc2db30_z.jpg


Anyway, so far, so good. If anything changes, I'll report back.
 
So any time you need me to fly that thing, Jes let me know.....
 
Back
Top